- 必威体育下载

姓名
邮箱
手机号码
标题
留言内容
验证码

Abstract

In recent years, nano-structures used as light harvesting have been widely used in perovskite cells to enhance the photon absorption of cells. The introduction of trapping structures in perovskite cells can change the photon propagation in the cell and the photon energy absorbed by the cell. The nano-structure used in different interfaces of perovskite cells can increase the absorption of light by the device to different degrees, and ultimately improve the efficiency of the solar cell. Therefore, the effective light trapping structure has become trending in the application of perovskite cells. How to effectively apply the such nano-structure is the key to improve the power conversion efficiency(PCE) of perovskite cells. So far, there is three ways including surface antireflection nanostructure, texture structure and plasmon nanostructure to apply to perovskite solar cell. The first one is ordered and disordered antireflection nanostructure that enhance the absorption of light on the surface of perovskite cells and makes visible light scatter at the interface of the nanostructure to reflection probability, the second one is texture structure that can not only improve the light absorption but avoid the formation of short-circuit channel inside the cell, the third one is plasmon nanostructure that can further improve the absorption of the thin film absorption material in the long band, so as to achieve the effect of improving the light utilization and cell efficiency. The trap structure is expected to achieve good photon absorption performance in wide spectral range and wide incidence angle range under the condition of reducing the thickness of active layer. At the same time, it has the advantages of good repeatability, easy to simulate and easy to change the structure. Therefore, using various trap technologies to design efficient trap structure has become a research hotspot in the field of solar cells. So far, most of the reports on the trapping structure have been applied to the silicon-based thin film solar cells, but few of them have been reported on the perovskite cells. This paper starts from the description of the perovskite cell with different nano-structures, comparing and summarizing the different structures, and analyzes the advantages and Disadvantage.

Keywords:

Authors and contacts

Corresponding author:Huang Qian,carolinehq@nankai.edu.cn

FullText HTML: translate this paragraph

References

[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
[23]
[24]
[25]
[26]
[27]
[28]
[29]
[30]
[31]
[32]
[33]
[34]
[35]
[36]
[37]
[38]
[39]
[40]
[41]
[42]
[43]
[44]
[45]
[46]
[47]
[48]
[49]
[50]
[51]
[52]
[53]
[54]
[55]
[56]
[57]
[58]
[59]
[60]
[61]
[62]
[63]
[64]
[65]
[66]

Cited By

DownLoad: Full-Size Img PowerPoint

Device structure	Source	J_SC/mA·cm^–2		V_OC/V		FF/%		PCE/%
Device structure	Source	Ref	ARC	Ref	ARC	Ref	ARC	Ref	ARC
PDMS/FTO glass/TiO₂/MAPbI₃/PTAA/Au	[37]	20.6	21.2	1.09	1.09	76.6	76.6	17.17	17.74
LMF/Glass/ITO/PEDOT:PSS/MAPbI₃/PCBM/BCP/Ag	[38]	20.7	21.7	1.11	1.11	70.9	71.2	16.3	17.1
LMF: Light management foil

DownLoad: CSV

Source	NSs	J_SC/mA·cm^–2		V_OC/V		FF/%		PCE/%
Source	NSs	Ref	NSs	Ref	NSs	Ref	NSs	Ref	NSs
[61]	Au@SiO₂80 nm spheres	14.8	16.9	1.02	1.04	64	67	10.7	11.4
[62]	Ag@TiO₂40 nm spheres	17.3	19.7	1.03	1.04	64	67	11.4	13.7
[63]	Au@SiO₂40 nm rods	13.9	17.4	1.17	1.16	66	68	10.7	13.7
[64]	Au-Ag 100 nm popcorn	15.5	16.5	0.92	0.95	63	66	8.9	10.3
[65]	Au/TiO₂Fibres	19.6	20.8	0.85	0.99	62	70	10.3	14.4
[66]	Au stars 20 nm	21.1	23	1.05	1.08	69	71	15.2	17.7

DownLoad: CSV

[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
[23]
[24]
[25]
[26]
[27]
[28]
[29]
[30]
[31]
[32]
[33]
[34]
[35]
[36]
[37]
[38]
[39]
[40]
[41]
[42]
[43]
[44]
[45]
[46]
[47]
[48]
[49]
[50]
[51]
[52]
[53]
[54]
[55]
[56]
[57]
[58]
[59]
[60]
[61]
[62]
[63]
[64]
[65]
[66]

[1]	Qu Zi-Han, Zhao Yang, Ma Fei, You Jing-Bi.Preparation of high-performance large-area perovskite solar cells by atomic layer deposition of metal oxide buffer layer. Acta Physica Sinica, 2024, 73(9): 098802.doi:10.7498/aps.73.20240218
[2]	Wang Shi-Dong, Yan Ya-Ting, Wang Rui-Ying, Zhu Zhi-Li, Gu Jin-Hua.Cesium doping for improving performance of inverse-graded 2D (CMA)₂MA₈Pb₉I₂₈perovskite film and solar cells. Acta Physica Sinica, 2023, 72(13): 138801.doi:10.7498/aps.72.20230357
[3]	Meng Jing, Gao Bo-Wen.Photovoltaic performance of novel Perovskite/organic integrated solar cells with high efficiency and high stability. Acta Physica Sinica, 2023, 72(1): 018802.doi:10.7498/aps.72.20221120
[4]	Han Xiao-Jing, Yang Jing, Zhang Jia-Li, Liu Dong-Xue, Shi Biao, Wang Peng-Yang, Zhao Ying, Zhang Xiao-Dan.Electron transport layer of tin dioxide deposited by reactive plasma and its application in perovskite solar cells. Acta Physica Sinica, 2023, 72(17): 178401.doi:10.7498/aps.72.20230693
[5]	Han Mei-Dou-Xue, Wang Ya, Wang Rong-Bo, Zhao Jun-Tao, Ren Hui-Zhi, Hou Guo-Fu, Zhao Ying, Zhang Xiao-Dan, Ding Yi.Improved electrical properties of cuprous thiocyanate by lithium doping and its application in perovskite solar cells. Acta Physica Sinica, 2022, 0(0): .doi:10.7498/aps.7120221222
[6]	Han Mei-Dou-Xue, Wang Ya, Wang Rong-Bo, Zhao Jun-Tao, Ren Hui-Zhi, Hou Guo-Fu, Zhao Ying, Zhang Xiao-Dan, Ding Yi.Improved electrical properties of cuprous thiocyanate by lithium doping and its application in perovskite solar cells. Acta Physica Sinica, 2022, 71(21): 217801.doi:10.7498/aps.71.20221222
[7]	Lu Hui-Dong, Han Hong-Jing, Liu Jie.Simulation and property calculation for FA_1–_xCs_xPbI_3–_yBr_y: Structures and optoelectronical properties. Acta Physica Sinica, 2021, 70(3): 036301.doi:10.7498/aps.70.20201387
[8]	Xu Ting, Wang Zi-Shuai, Li Xuan-Hua, Sha Wei E. I..Loss mechanism analyses of perovskite solar cells with equivalent circuit model. Acta Physica Sinica, 2021, 70(9): 098801.doi:10.7498/aps.70.20201975
[9]	Li Yan, He Hong, Dang Wei-Wu, Chen Xue-Lian, Sun Can, Zheng Jia-Lu.Research progress of light irradiation stability of functional layers in perovskite solar cells. Acta Physica Sinica, 2021, 70(9): 098402.doi:10.7498/aps.70.20201762
[10]	Lu Hui-Dong, Han Hong-Jing, Liu Jie.Structure optimization and optoelectronical property calculation for organic lead iodine perovskite solar cells. Acta Physica Sinica, 2021, 70(16): 168802.doi:10.7498/aps.70.20210134
[11]	Chen Yong-Liang, Tang Ya-Wen, Chen Pei-Run, Zhang Li, Liu Qi, Zhao Ying, Huang Qian, Zhang Xiao-Dan.Progress in perovskite solar cells based on different buffer layer materials. Acta Physica Sinica, 2020, 69(13): 138401.doi:10.7498/aps.69.20200543
[12]	Liang Xiao-Juan, Cao Yu, Cai Hong-Kun, Su Jian, Ni Jian, Li Juan, Zhang Jian-Jun.Simulation and architectural design for Schottky structure perovskite solar cells. Acta Physica Sinica, 2020, 69(5): 057901.doi:10.7498/aps.69.20191891
[13]	Wu Bu-Jun, Lin Dong-Xu, Li Zheng, Cheng Zhen-Ping, Li Xin, Chen Ke, Shi Ting-Ting, Xie Wei-Guang, Liu Peng-Yi.Optimization of grain size to achieve high-performance perovskite solar cells in vapor deposition. Acta Physica Sinica, 2019, 68(7): 078801.doi:10.7498/aps.68.20182221
[14]	Li Hai-Tao, Jiang Ya-Xiao, Tu Li-Min, Li Shao-Hua, Pan Ling, Li Wen-Biao, Yang Shi-E, Chen Yong-Sheng.Influence of annealing temperature on properties of Cu2O thin films deposited by electron beam evaporation. Acta Physica Sinica, 2018, 67(5): 053301.doi:10.7498/aps.67.20172463
[15]	Li Shao-Hua, Li Hai-Tao, Jiang Ya-Xiao, Tu Li-Min, Li Wen-Biao, Pan Ling, Yang Shi-E, Chen Yong-Sheng.Quality management of high-efficiency planar heterojunction organic-inorganic hybrid perovskite solar cells. Acta Physica Sinica, 2018, 67(15): 158801.doi:10.7498/aps.67.20172600
[16]	Wang Jun-Xia, Bi Zhuo-Neng, Liang Zhu-Rong, Xu Xue-Qing.Progress of new carbon material research in perovskite solar cells. Acta Physica Sinica, 2016, 65(5): 058801.doi:10.7498/aps.65.058801
[17]	Wang Fu-Zhi, Tan Zhan-Ao, Dai Song-Yuan, Li Yong-Fang.Recent advances in planar heterojunction organic-inorganic hybrid perovskite solar cells. Acta Physica Sinica, 2015, 64(3): 038401.doi:10.7498/aps.64.038401
[18]	Chen Pei-Zhuan, Hou Guo-Fu, Suo Song, Ni Jian, Zhang Jian-Jun, Zhang Xiao-Dan, Zhao Ying.One-dimensional photonic crystal(1D PC)-based back reflectors for amorphous silicon thin film solar cell. Acta Physica Sinica, 2014, 63(7): 077301.doi:10.7498/aps.63.077301
[19]	Qin Fei-Fei, Zhang Hai-Ming, Wang Cai-Xia, Guo Cong, Zhang Jing-Jing.Design and simulation of anodic aluminum oxide nanograting double light trapping structure for thin film silicon solar cells. Acta Physica Sinica, 2014, 63(19): 198802.doi:10.7498/aps.63.198802
[20]	Yu Xiao-Ming, Zhao Jing, Hou Guo-Fu, Zhang Jian-Jun, Zhang Xiao-Dan, Zhao Ying.Investigation of light trapping structure and performance in PIN-type and NIP-type thin film silicon solar cells. Acta Physica Sinica, 2013, 62(12): 120101.doi:10.7498/aps.62.120101

Catalog

Vol. 69, Issue 7 - 2020-04-05

Metrics

Abstract views:11217
PDF Downloads:342
Cited By:0

Search

Article