Er ³⁺-doped ZBLAN fiber laser is a promising approach to producing 2.8 μm mid-infrared (MIR) laser. The long lifetime of the lower-laser-level ⁴I _13/2often results in serious self-terminating effect which harms the laser power and efficiency significantly, especially for the active fiber with low dopant concentration which is preferred for weak thermal issues but cannot depopulate the lower-laser-level effectively via the up-conversion process. The 1.6 μm lasing ( ⁴I _13/2→ ⁴I _15/2) in Er-ZBLAN fiber could deplete the population on ⁴I _13/2. Therefore, cascaded 2.8 μm and 1.6 μm lasing in Er ³⁺-doped ZBLAN fiber provides a promising solution to the self-termination effects on laser power scaling. Moreover, the ⁴I _13/2→ ⁴I _15/21.6 μm laser also has some overlap with the ⁴I _13/2→ ⁴I _9/2excited state absorption (ESA) spectrum. The ions on the ⁴I _9/2level would then relax to the upper-laser-level of 2.8 μm lasing ( ⁴I _11/2), and results in enhanced laser efficiency. In general, the 1.6 μm cascaded lasing in 2.8 μm Er-ZBLAN fiber laser involves both lasing and ESA. The two processes have different spectra and different influences on the 2.8 μm laser gain. Therefore, there should exist an optimal wavelength of the 1.6 μm laser, which would balance the two processes, ensuring the lower-laser-level depopulation while maximizing the ion recycling. Therefore, we develop a comprehensive numerical model of cascaded 2.8 μm and 1.6 μm lasers based on Er-ZBLAN fiber. After the numerical model is verified by the previous experimental results, the effects of MIR and 1.6 μm lasing wavelengths on the power and conversion efficiency of 2.8 μm laser are investigated in depth. The results show that a suitable trade-off between the two processes can be reached with the cascaded lasing wavelength of 1610 nm, for the optimized 2.8 μm laser power/efficiency. Moreover, the influence of 1.6 μm laser cavity feedback on the power/efficiency characteristics of the 2.8 μm laser is also investigated. It is found that the feedback at 1.6 μm is very low, even only 4% is provided by the Fresnel reflection of the fiber facet, which can effectively generate 1.6 μm laser and significantly improve the efficiency of 2.8 μm laser.